DF DIGITALFOTO Ares Z Axis Suspension Dual Grip Flexible Damping Removable Dual Grip Gimbal Handle Compatible with Ronin S Ronin SC Crane 2 3 Axis Gimbal

• With suspension: make 3-axis gimbal 5-axis gimbal 30% stability improvement
• Compatibility: It is compatible with all brands of one-handed gimbal stabilizers with a handle diameter of 40-46mm. It comes with round accessories that can be installed with a quick base plate where cameras, camcorders, etc
• Shock absorption design: It adopts oil pressure assisted fine adjustment design, can achieve the fine adjustment rebound force according to different load and different use environment to achieve shock absorption effect.
• Material is aluminum alloy and removable: it is removable, you can change the alignment of both hands up and down for your shots
• 1/4 Threaded Hole: The handle has a 1/4 thread for connecting to monitors, microphones and other accessories

Adapter of DJI Ronin Tethered Control Handle on ARES Z AXIS MAGIC RING

For connecting DJI Ronin Tethered Control Handle and ARES Z AXIS 



Overview:

If your gimbal handle diameter is smaller than 40mm,like 31mm Zhiyun Crane Plus&Crane V2,then you need to insert our round base plate into Ares middle connect bridge clamp,tighten it,and then install gimbal on top of the round base plate via 1/4” screw.

World first Z axis alloy spring dual handle for Ronin S,also compatible with any 40-46mm handle including FEIYU/ZHIYUN/DJI/MOZA Single handle gimbal
30% reduce vertical vibration
One tighten knob to tight gimbal，Save time!

Why Choose DF DIGITALFOTO ARES Z Axis Spring Dual Handle?

1.One tighten knob to tight gimbal   
2.With anti-scratch rubber mat,your gimbal handle will be protected
3.Compatible with 40-46mm handle like Ronin S/ Zhiyun Crane 2/Crane V2/Crane Plus/Feiyu Series Gimbal
4.With Spring arm design,effectively 30% reduce vertical bounce 
5.1/4 threaded hole on handle top for installing LED/Microphone/Monitor etc
6.Handle is connected to the arm by anti-slip gear,which avoid handle moving especially for using Ronin S
7.Weight Bear 1.8-5kg,can meet most gimbal with camera+others
8.Adjust arm tension to achieve best condition for your balance and shooting
9.Anti-slip rubber handhold
10.By changing handhold direction,you can achieve inverted shooting
11.Detachable design ,which make it portable
12.Small raised nails ensure the arms will not fall down
13.Net weight 1kg,ensure not add too much weight for two hand

Standard Configuration

Spring Arm with Handle*2
Middle Connect Bridge*1
Round Baseplate*1
Tube for Wireless Controller*1
Screw *1
L Screwdriver*1

Specification:

Compatible:40-46mm handle like Ronin S/ Zhiyun Crane 2/Crane V2/Crane Plus/Feiyu Series Single Handle Gimbal
Vibration reduce:30%
Weight Load:1.8-5kg